Whirlpool WFC8090GX Use And Care Manual And Installation Instructions page 67

CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER
NOTE: Perform the following procedure every 6 months.
1. Open the drain pump filter access door at the bottom right
corner at the front of the washer/dryer.
2. Place a broad, flat pan beneath the drain pump filter to
collect the drain water. Pull out the black hose, remove
the plug, and drain the hose into the pan. Empty the
pan. Replace the drain hose plug and put the hose back
into place. Repeat this procedure if necessary until all
the water has drained. Make sure that the black hose is
completely dry.
Black hose
CLEANING THE DRAIN PUMP FILTER/
DRAINING RESIDUAL WATER (cont.)
3. Lay a cotton cloth beneath the drain pump filter to absorb
any water still in it. Then remove the drain pump filter by
turning it counterclockwise.
4. Remove large clumps of lint by hand from the filter and
place lint in a suitable waste container. Remove remaining
residue from the filter by rinsing with water.
5. Reinsert the drain pump filter by turning it clockwise.
Make sure to turn it in as far as it will go, with the filter
handle left in a vertical position.
67