Lint screen
Clean the lint screen
before
each
load. A screen blocked
by lint can
increase
drying
time and may be a FIREHAZARD,
The lint screen
is
2.
inside the dryer
Pull
drum, on the
straight
back wall.
out.
I. Use the finger
holes to pull
the lint screen
3.
straight
out.
_
ARNING: DO NOT run the
dryer with the lint screen
loose, damaged
or missing.
Doing so can cause over-
heating, can damage
fabrics
and
can be a FIRE HAZARD.
4.
5.
Lightly
squeeze
the
body, as
shown, while
pulling
the
cover
off,
\
Roll lint off the
\
screen
with
your fingers.
Squeeze
body;
DO NOT rinse
pull cover off.
or wash the
screen.
Wet lint is hard to remove.
Replace
the cover
on the body
of
the lint screen.
Push the lint screen
straight
back
in until it clicks
into place
Lint removal
Lint can gather
inside the dryer
and create
a fire hazard.
This lint should be removed
every 2 to 3 years, or more often,
depending
on dryer usage.
Cleaning
should be done only by a qualified
service
person.
t. Remove
back
panel
from dryer.
2. Avoid touching
thermostats,
wires, terminals
and heater
box.
3. Remove
lint from shaded
area
- see art - with a soft brush or
vacuum
cleaner.
4. Replace
back
panel.
Recon-
nect,
exhaust
duct, etc.
Level the washer/dryer.
* Avoid electrical shock
hazard- unplug power
supply cord or turn off
electrical power.
• Avoid injury or damage-do
not
put hands inside cabinet.
• Metal edges may be sharp.
• Make sure dryer is cool.
I
hermostats
IJ[I
HeaterBox
Exhaust Duct Outlet
Heat Element Terminals
15