Table of Contents
Advertisement
Available languages
Available languages
V 4.1
5.
Place one of the upper crossbeams (#10) to align the top hole in the beam
with the top hole in the left post. Insert a bolt (#9) so it protrudes inside
the post. Secure with a washer (#13), a lock washer (#12) and nut (#11),
but leave it loose enough to move the crossbeam.
6.
Repeat step 6 with the other upper crossbeam (#10) on the other side of
the same post. You will have two cross beams connected at the upper
corner to the post.
7.
Slide the under plate (#7) onto both upper beams so the hooks are over
the bottom lip of each beam.
8.
Secure the remaining 6 bolt holes in the posts and upper crossbeams with
bolts (#9), washers (#13), lock washers (#12) and nuts (#11) as in step 6.
All nuts should be hand tight to allow the under plate to be repositioned
before final tightening.
9.
Raise the shop press frame upright.
10. Thread the pressure gauge (#1) into the pressure gauge connection nut at
the top of the ram (#3).
11. Thread the upper round nut (#6) onto the ram (#3) until it reaches the
top threads.
12. Slide the ram through the opening in the under plate until the upper round nut
is sitting on top of the plate. Position so the pressure gauge is facing the front.
13. Thread the under round nut (#8) onto the ram from beneath and tighten to
secure the ram to the under plate.
14. Center the ram assembly in relation to the frame. Tighten the nuts securing the
upper crossbeams to the posts with a wrench to hold the ram in place during
operation.
15. Push each bed frame pin (#19) through the matching set of holes on the left
and right side of the frame. The bed frame (#18) will rest on these, so ensure
they are level with each other.
16. Position the bed frame so the beams are outside of the leg assemblies. Lower
until the bed frame is resting on the pins.
17. Secure the pump assembly with bolts (#29) and washers (#14). The bolts are
inserted through the post and into screw holes in the pump's mounting frame.
Visit www.princessauto.com for more information
20 Ton Hydraulic Shop Press
8604597
7
Advertisement
Table of Contents
