Proswap Logger Power Supply - Xylem ProSwap 610224-01 User Manual

1.3

ProSwap Logger Power Supply

There are two different versions of the ProSwap Logger – one with an internal, rechargeable lithium ion battery
and one without.
Internal Battery Version
Models:
• 610150-XX
• 610151-XX
• 610152-XX
This version includes a built-in, rechargeable lithium ion battery. This battery, fully charged, will last at least 90 days at a 15 minute
log interval no matter which ProDSS Sensor is installed and may last longer depending on the sensor type.
Full recharge time may take up to 14 hours depending on the power source.
This battery can be recharged by connecting the cable to a handheld meter (ProSwap or ProDSS). The ProSwap Logger will drain
the battery of the handheld to charge its own battery. Plug the handheld's USB connector into the AC power adapter or a computer
USB connector to maintain charging.
Alternatively, the battery can be charged using the USB adapter accessory (sold separately). Plug the USB cable into the AC power
adapter or a computer USB connector to enable charging.
Non-Battery Version
Models:
• 610153-XX
• 610154-XX
• 610155-XX
This version features no onboard power and therefore requires an external power supply. Options for external power include the
following:
• ProSwap or ProDSS Handheld – The handheld will power the logger as long as it is connected and powered on.
• ProSwap Logger AA Power Pack – The power pack utilizes six AA batteries to provide power to the logger for at least 90 days at
a 15 minute logging interval.
• USB Adapter – The USB Adapter will power the logger when connected to a PC USB port or AC adapter.
• Flying Lead Adapter – The flying lead adapter may be used to supply external power (9-16 V) and provide communication with
a data logger.
Introduction
8