Table of Contents
Advertisement
6. Identify the Right Upper Body Arm (61) and the
Right Upper Body Leg (60), which are marked
with "Right" stickers, and orient them as shown.
Make sure that the hexagonal holes are in
the indicated location.
Slide the Right Upper Body Arm (61) onto the
Right Upper Body Leg (60).
Attach the Right Upper Body Arm (61) with two
M8 x 38mm Bolts (96) and two M8 Locknuts
(102). Make sure that the Locknuts are in the
hexagonal holes.
Repeat this step for the Left Upper Body
Arm (not shown) and the Left Upper Body
Leg (not shown).
7. Apply a small amount of grease to the Pivot
Axle (35) and to a 16mm Wave Washer (54).
Insert the Pivot Axle (35) through the Upright (4)
and then center it.
Slide the 16mm Wave Washer (54), an Inner
Arm Cover (68), and the Right Upper Body Leg
(60) onto the right side of the Pivot Axle (35).
Repeat this step for the Left Upper Body Leg
(not shown).
Tighten an M8 x 19mm Patch Screw (82) and
an M8 x 25mm Washer (98) into each end of
the Pivot Axle (35).
6
61
102
96
7
4
Grease
35
54
8
Hexagonal
Holes
60
68
60
98
82
Advertisement
Table of Contents
