Assembly - ICON PROFORM 505 ZLE User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M8 Split 16mm Wave 19mm Wave M10 Washer
M8 x 25mm
Washer (54)–2 Washer (66)–4
(95)–2
Washer (83)–13
Washer (98)–6
M8 Locknut M10 Locknut M4 x 16mm M8 x 16mm Patch M8 x 19mm Patch
(102)–4 (92)–2 Screw (104)–10 Screw (110)–4 Screw (82)–15
M8 x 38mm M8 x 80mm Patch
Bolt (96)–4
Screw (84)–2
M10 x 60mm
M10 x 45mm Patch
Screw (99)–4 Bolt (100)–2
5