Table of Contents
Advertisement
10. Attach the Right Pedal Arm (58) to the Right
Pedal Bracket (64) with two M10 x 45mm Patch
Screws (99).
Repeat this step for the Left Pedal Arm (44).
11. Identify the Right Handlebar (9), which is
marked with a "Right" sticker.
See the inset drawing. Locate the wire tie in
the Upright (4). Tie the lower end of the wire tie
to the Pulse Wire (63) in the Right Handlebar
(9). Next, pull the upper end of the wire tie until
the Pulse Wire is routed through the Upright.
Then, slide the Right Handlebar (9) onto the
right side of the Upright (4).
Tip: Avoid pinching the wires. Attach the
Right Handlebar (9) with two M8 x 16mm Patch
Screws (110) and two M8 Split Washers (83).
Repeat this step for the Left Handlebar (8).
Tip: To prevent the Pulse Wires (63) from
falling into the Upright (4), secure the Pulse
Wires with the wire ties.
10
44
11
63
8
4
Wire Tie
63
10
64
99
Avoid pinching
the wires
Wire Tie
63
9
83
110
58
Advertisement
Table of Contents
