Canon MultiPASS F50 Fax Manual page 33

Memory sending using the platen glass
• When documents are loaded into the ADF, the machine will scan documents not on the platen glass but
in the ADF. You need to remove documents from the ADF in advance.
NOTE
1
Press Fax to set Fax Mode.
1 2 / 0 3 / 2 0 0 1 M O N 1 5 : 3 0
F a x T e l
Ex:
2
Prepare the document and place it on the
platen glass.
(→ Reference Guide)
• For color sending, press Color/B&W to turn on
its light. (→ p. 4-1)
• To adjust the resolution and contrast, → p. 4-2.
3
Dial the other party's fax number.
T E L =
Ex:
• For dialing methods, → p. 4-3.
• If you enter the wrong number, press
Stop/Reset, then enter the correct number.
• If you must first dial a digit to get an outside line
("9", for example), add a pause after that digit by
pressing Redial/Pause.
4
Press Start to begin scanning.
• When you use speed dialing, scanning starts
automatically after a few seconds if the TIME
OUT setting is on. (→ p. 9-5)
N E X T P A G E
E N D S C A N N I N G : S E T
• If you want to scan other documents, set the next
document on the platen glass and press Start.
S T A N D A R D
9 0 5 7 9 5 1 1 1 1
: S T A R T
5
Press Set to send.
• To cancel sending after dialing has started, press
Stop/Reset then T. (→ p. 4-9)
• You can scan up to 30 different documents
for memory sending.
NOTE
• When an error occurs during sending, the
document is automatically deleted from
memory, even if it was not sent completely.
• If you send a color document to a fax
machine that does not support color faxing,
or TRY AGAIN IN B&W will be
displayed in the LCD, → p. 4-1.
4
4-7