Table of Contents
Advertisement
Redialing
Manual
To start dialing again, just press
previous number you dialed with the numeric buttons. Make sure the
document is in the ADF.
Automatic
The MultiPASS automatically redials if the first attempt at sending fails
(for example, if the line is busy). The unit redials twice, and the time
between redials is two minutes. (These are the default settings.) The
LCD displays
MultiPASS is redialing.
If the MultiPASS fails to make a connection after the last redial, it
beeps. The LCD displays
You can change the number of redials (retries) and the time between
redials. The redialing options are set in the Send Fax dialog box of the
MultiPASS Desktop Manager; see page 8-4.
Chapter 4
If there is no group registered under the one-touch speed
dialing button or the two-digit code, the LCD displays the
message. Make sure you entered the correct
NO TEL #
number and that the group has been registered correctly
to a speed dial code. (See page 8-13.)
If you make a mistake when dialing, press
then try again.
REDIAL
and the transaction number while the
AUTO REDIAL
AUTO REDIAL
TX/RX NO.
XXXX
BUSY/NO SIGNAL
BUSY/NO SIGNAL
Sending Faxes With the MultiPASS C5500
. You can
STOP
. The MultiPASS redials the
; try sending again later.
4-7
Advertisement
Table of Contents
