Page 2
• Any unauthorized transfer or copying of this document, in part or in whole, is prohibited. • Shinko Technos Co., Ltd. is not liable for any damage or secondary damage(s) incurred as a result of using this product, including any indirect damage.
• Mount the DIN rail horizontally. When the DIN rail is mounted vertically, be sure to use commercially available fastening plates at both ends of the DCL-33A series. However, if the DIN rail is mounted horizontally in a position susceptible to vibration or shock, the fastening plates must be used as well.
: 19200 bps : 38400bps Parity Even •Selects the parity. • Available only when serial communication (C5 option) is ordered. Not available if Shinko protocol is selected in [Communication protocol]. • No parity Even Stop bit 1 bit •Selects the stop bit.
Page 42
Error detection: Parity check, checksum (Shinko protocol), LRC (MODBUS ASCII), CRC-16 (MODBUSRTU) Digital external setting: Step SV can be received from the connected Shinko programmable controllers PCA1 or PCB1. („SV digital transmission‟ should be selected in [Communication protocol] on the PCA1 or PCB1.) When data from the programmable controller is larger than SV high limit or smaller than SV low limit, DCL-33A ignores the value and controls with the previous value.
Need help?
Do you have a question about the DCL-33A Series and is the answer not in the manual?
Questions and answers