C.7: Annunciator Programming; C.8: Operation - Honeywell NOTIFIER LDM Series Instruction Manual

NFS2-3030 and NCA-2 (UL 9th), AM2020/AFP1010, NFS-3030, or NCA (UL 8th)
C.7 Annunciator Programming
LDM points must be programmed from the FACP before the LDM will function. The NFS2-3030, NFS-3030, NCA-2, NCA and
AM2020/AFP1010 employ the following format for annunciator points:
For programming the Lamp Driver Series into the FACP or network annunciator's memory, and for mapping system points and software
zones to annunciator points, refer to the appropriate FACP/network annunciator documents referenced in Section 1.3, "Related Docu-
mentation", on page 7. In the NFS2-3030, NFS-3030, NCA-2, and NCA documentation, refer to the sections about ACS Programming
and ACS Point Programming. In AM2020/AFP1010 documentation, refer to the sections about Programming for Remote Annunciation.
C.8 Operation
LDM points 'track' or follow those system points they are programmed to annunciate; the points do not latch unless latched by the panel.
Table C.1 is a list of how the LDM-32 annunciates various AM2020/AFP1010 devices and functions; all functions are the same for NFS-
3030/NFS2-3030/NCA/NCA-2. Note: Control Switches marked 'not used' will still function as local LAMP TEST switches for their
respective LEDs.
For more information on LDM operation and FACP programming under various specific applications, refer to the appropriate FACP/net-
work annunciator documents referenced in Section 1.3, "Related Documentation", on page 7.
46
LDM (Annunciator) address
is the range of 1-32, as set on the
annunciator's rotary decimal switches.
LDM-32
LDM Alarm/Trouble Mode:
points 1-16
LDM-32
LDM Alarm Only Mode:
points 1-32
Point Type Alarm Mode Only
Red LED
Control Module Indicates on/off status
XPC Circuit of module or circuit
XPR Circuit
Monitor Module Indicates active status
XPM Circuit of module or circuit
Intelligent Detector Indicates fire alarm
status of detector
Software Zone Indicates active status
of software zone
ACK/STEP key Indicates Fire Alarm
SIGNAL SILENCE not used
key
SYSTEM RESET Indicates Fire Alarm
key
LAMP TEST key not used
Table C.1 Lamp Driver Point Functions
A(xx) P(yy)
LDM (Annunciator) point
1st LDM-E32 2nd LDM-E32
points 17-32
points 38-48
1st LDM-E32
points 33-64
Alarm and Trouble Mode
Yellow LED Control Switch
Indicates trouble/ Turn module on/off
supervisory status of
module or circuit
Indicates trouble/
supervisory status of
module or circuit
Indicates trouble
status of detector
Indicates trouble/
supervisory status of
software zone
Indicates System Functions as an
Trouble ACK/STEP key
Indicates Signals Functions as a SIGNAL
Silenced
Indicates System Functions as a
Trouble SYSTEM RESET key
not used Functions as a LAMP
LDM Series Instruction Manual — P/N 15885:H3 8/12/2019
Annunciator Programming
3rd LDM-E32
points 49-64
not used
not used
not used
SILENCE key
TEST key