Honeywell NOTIFIER LDM Series Instruction Manual page 37

AIM-200 Point Annunciation
Figure B.4 illustrates the configuration of LDMs to annunciate alarms for up to 120 zones (no zone troubles) with the first eight points
(P1 through P8) dedicated to the System 5000unctions listed below. (Control switches do not function in Alarm Only configuration).
Figure B.5 illustrates the configuration of LDMs to annunciate alarms for up to 56 zones (no zone troubles) with the last eight points
(P57 through P64) dedicated to the System 5000 function annunciations listed below. (Control Switches do not function in Alarm Only
mode).
LDM Series Instruction Manual — P/N 15885:H3 8/12/2019
Address #1
LDM-32
System Functions *
LDM-E32
25 - 32
Address #2
LDM-32
57 - 64
LDM-E32
89 - 96
J5
* System Status Indicators
Notification Circuit #1 ON (Green LED)
System Alarm (Red LED)
*It is assuming this module/expander annunciates points (circuits) 65-128 and is not
functioning as a Receive Only annunciator.
Figure B.4 Alarm Only Operation Without 8-Point Shift
Address #1
LDM-32
1 - 8
LDM-E32
33 - 40
J5
* System Status Indicators
Notification Circuit #1 ON (Green LED)
System Alarm (Red LED)
*It is assumed that the '8-Point Shift' will be selected only on systems containing less than 56
zones/points or a total of 64 annunciator points or less.
Figure B.5 Alarm Only Operation with 8-Point Shift
17 - 24
1 - 8
9 - 16
49 - 56
33 - 40
41 - 48
65 - 72 73 - 80 81 - 88
97 - 104 105 - 112 113 - 120
J6
OUTPUTS J7
view of LDM-32
Notification Circuit #2 ON (Green LED)
Municipal Tie ON (Red LED)
not
Alarm Relay ON (Red LED)
J5
9 - 16
17 - 24
41 - 48 49 - 56
System Functions *
J6
OUTPUTS J7
view of LDM-32
Notification Circuit #2 ON (Green LED)
Municipal Tie ON (Red LED)
not
Alarm Relay ON (Red LED)
used
J8
System 5000 (UL 8th)
wire to
LEDs
J8
25 - 32
wire to
LEDs
J8
37