Table of Contents
Advertisement
IP Map/RIP Direction
Write security: 3, Read security: 5
This parameter allows the direction at which RIP advertisements
are sent and listened to be specified.
Tx and Rx
(def)
Tx Only
Rx Only
DLCI Mapping/IPX Map
This menu represents the IPX protocol mapping that is to take place
for this DLCI.
IPX Map/Active
Write security: 3, Read security: 5
When set to Yes (def), the Router Option Module will attempt to
transport IPX packets for this DLCI.
When set to No, no IP traffic or route will be exchanged.
IPX Map/IARP
Write security: 3, Read security: 5
When set to Yes (def), the Router Option Module will send Inverse
ARP packets in order to determine the IPX network on the other end
of the virtual circuit. If the IARP is responded to, a route is placed
in the IPX route table.
When set to No, the IPX network is to be assigned to the link stati-
cally using the IPX Map/Link Network parameter.
IPX Map/Link Network
Write security: 3, Read security: 5
This is the IPX network of the link or of the other devices LAN.
When this DLCI becomes active, the Router Option Module will add
a route to this network in the IPX routing table. This address is also
used by the Router Option Module to respond to Inverse ARP re-
quests. If this IPX address is left as 0, the link is treated as unnum-
bered and the Router Option Module responds to the Inverse ARP
with its Ethernet IP address.
61200350L1-1
Chapter 4: Configuration Overview
RIP advertisements are periodically transmitted
and are listened to on this virtual circuit.
RIP advertisements are periodically transmitted
but are not listened to on this virtual circuit.
RIP is not transmitted on this virtual circuit but
they are listened to.
Router Option Module User Manual
4-31
Advertisement
Table of Contents
