Table of Contents
Advertisement
Call Log Messages
Power Up - last down cause: <reason>
level 0 (displayed as level 1 after the unit is reset)
This is the <reason> for the last reset. Most are caused by internal
errors. Possible reasons are:
Bus error
Kernel error
No SBCs
Router stack error
General panic
No rip
Out of memory
Out of TCP ports
Unknown error
Set timer error
Software watchdog
reset
61200.350L2-1
Bad address occurred on the internal bus
General operating system error
Mail resources used up or lost
Fatal error in protocol stack
General error
Rip tasks could not start
Out of available memory
All TCP ports are used up
Unknown fatal error has occurred
Cannot set real-time clock
Software watchdog was not updated
Router Option Module User Guide
Appendix C: Log Messages
C-5
Advertisement
Table of Contents
