Toro Workman GTX Series Installation Instructions Manual page 4

6. Insert the assembled spreader mount into the machine
receiver tube (Figure
Figure 7
1. Receiver tube
7. Secure the assembled spreader mount to the receiver
tube using the clevis pin and hairpin cotter
Figure 8
1. Clevis pin
8. Tighten the "T" handle on the receiver tube
Figure 9
1. "T" handle
7).
2. Assembled spreader
mount
(Figure
2. Hairpin cotter
(Figure
Important: If you use the spreader mount while in
transport mode without the spreader installed , secure
the spreader-ramp assembly using the 2 snap pins as
shown in Figure
1. Snap pins
8).
9).
4
10.
Figure 10