Siemens ST950 Handbook page 106

The UTMC OTU licence controls whether or not connection to Stratos is supported
– see section 7.4.4.
Ethernet Configuration
Ethernet can be fully configured manually if required but configuration can be
minimised by using DHCP.
To connect the equipment to Stratos perform the following:
1. Set the date and time (System - Settings - System Date & Time - Set System
Date & Time web page).
2. On the System - Settings - Comms – Stratos web page:
•
Set the Tenant Pass Phrase.
•
Set the Site Location.
•
Set the Site Name.
3. Set the profile to Stratos (System – Settings web page).
4. Check that Ethernet is suitably configured (System - Settings - Comms -
DSL/Fibre web page). Using the Stratos profile sets this to DHCP. If this not
suitable then configure as required.
5. Connect the Ethernet port to a network which has connectivity to the services
described above.
Setting the Site Name, Site Location & Tenant Pass Phrase
These items are set on the System – Settings – Comms – Stratos configuration web
page.
Specifying a Tenant Pass Phrase prior to initial connection allows the equipment to
be automatically allocated to the specified tenant on initial connection to Stratos. If
the Tenant Pass Phrase is not specified at the time of initial connection then the
equipment will be allocated to the Siemens Support team who can then make the
allocation when required based on the outstation name, unique site id and
destination tenant. This item has no effect after initial connection to Stratos.
Security classification Unrestricted
Version 7
Last Editor manpreet.jeerh
Document Name ST950 ICM Handbook
Copyright © Siemens plc 2020. All Rights Reserved.
Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Page
Status
Date
Document No.
Mobility is a division of Siemens Plc
106 of 154
Issued
January 2020
667/HE/45950/000