Intelligent Detector Backplane Card Leds - Siemens ST950 Handbook

GSPI comms
OUT to next
Figure 23 – Intelligent Detector Backplane (rear view)

4.11.1 Intelligent Detector Backplane Card LEDs

The Intelligent Detector Backplane Card has three tri-colour status LEDs which are
identical to the LEDs on the I/O card as described in section 4.9.1 above. It should
be noted that these LEDs are viewed from above and are seen in reverse order (i.e.
LP3, LP2 and LP1 from left to right). For this reason, the table below shows the
LEDs in the order they are seen.
Watchdog LED
(LP3)
Off
Red
Off
Off
Off
Security classification
Version
Last Editor
Document Name
Copyright © Siemens plc 2020. All Rights Reserved.
Address
IDB Switch
Software Run LED
(LP2)
Yellow
Yellow
Green Steady
Green Flash
Green Flash
Unrestricted
7
manpreet.jeerh
ST950 ICM Handbook
Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
GSPI comms
IN from
Processsor or
previous IDB
Comms Active LED
(LP1)
Yellow
Yellow
Off
Red
Green Toggle on
Receipt of Message*
Page
Status
Date
Document No.
Mobility is a division of Siemens Plc
Input 24V DC- /AC
Input 24V DC+ /AC
Output 24V DC- /AC
Output 24V DC+ /AC
Twist and Flat Ribbon
Cable to Loop
Termination Board
State
Processor Reset
Watchdog Failure
Performing Start Up
Awaiting Start
Communications
Active
54 of 154
Issued
January 2020
667/HE/45950/000