Recording; Recording On A Tape - JVC UX-H35 Series Instructions Manual

Recording

IMPORTANT:
• It may be unlawful to record or play back
copyrighted material without the consent of the
copyright owner.
• The recording level is automatically set correctly, so
it is not affected by the other sound settings. Thus,
during recording you can adjust the sound you are
actually listening to without affecting the recording
level.
• If recordings you have made have excessive noise or
static, the unit may be too close to a TV. Increase the
distance between the TV and the unit.
• You can use type I tape for recording.
To protect your recording
Cassettes have two
small tabs on the
back to protect from
unexpected erasure
or re-recording.
To protect your recording, remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
At the start and end of cassette tapes
There is leader tape which cannot be recorded onto. Thus,
when recording discs or radio broadcasts, wind the leader tape
first to ensure that the recording will be made without any
loss.

Recording on a Tape

On the unit ONLY:
1
Put a recordable cassette in with the
exposed part of the tape down.
2
Close the cassette holder gently and
check the recording direction for the
tape.
• If the tape direction is not correct, press 2 3
TAPE twice then 7 to change the tape direction.
• If you want to record on both sides of a tape, see
"To record on both sides—Reverse Mode."
3
Start playing the source—FM, AM or
auxiliary equipment connected to AUX
jacks.
• When the source is the CD player, see "Disc
Direct Recording" on page 19.
4
Press ONE TOUCH
REC (recording).
The (recording) indicator
REC
lights up on the display and recording starts.
• If no cassette is inserted when you press REC
"NO REC" appears on the display.
• If a protected tape is inserted when you press REC
"NO REC" appears on the display.
To stop while recording, press 7.
To remove the cassette, press ) on the
unit.
To record on both sides—Reverse Mode
On the remote control ONLY:
Press REV.MODE (reverse mode)
repeatedly until or
• When using the Reverse Mode for
recording, lights up and start
recording in the forward (3) direction first.
Otherwise, recording will stop when recording is
done only on one side (reverse) of the tape.
Continued
ONE TOUCH
REC
REV.MODE
is lit.
18