Common Operations; Setting The Clock; Setting The Am Tuner Interval Spacing - JVC UX-H35 Series Instructions Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the unit's
clock. When you plug in the power cord, the CLOCK
indicator and "0:00" start flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step 1 .
On the remote control:
1
Press CLOCK/TIMER.
The hour digits start flashing on the
display.
CLOCK
2
Press UP or
adjust the hour, then press
CLOCK/TIMER.
The minute digits start flashing.
CLOCK
3
Press UP or
minute, then press CLOCK/TIMER.
CLOCK
On the unit:
1
Press TIMER/SNOOZE.
The hour digits start flashing on
the display.
2
Press ¢ or 4 to
adjust the hour, then
press TIMER/SNOOZE.
The minute digits start flashing.
3
Press ¢ or 4 to adjust the minute,
then press TIMER/SNOOZE.
CLOCK
/ TIMER
UP
DOWN to
DOWN
CLOCK
/ TIMER
DOWN to adjust the
TIMER/SNOOZE
TIMER/SNOOZE
To check the clock time during play
On the remote control ONLY:
Press DISPLAY (grey-colored).
• Each time you press the button, the
source indication and the clock time
alternate on the display.
• When you unplug the power cord or if a power failure
occurs
The clock is reset to "0:00" right away. If this happens, set
the clock again.
• The clock may gain or lose 1 to 2 minutes per month
If this happens, reset the clock.
To change the clock
1 Make sure the (timer) indicator is not lit on
the display.
• If it is lit, press and hold CLOCK/TIMER (or
TIMER/SNOOZE on the unit) until it goes off.
2 Press CLOCK/TIMER (or TIMER/SNOOZE
on the unit) repeatedly until the unit enters the
clock setting mode (the hour digits start flashing
on the display).
First time you press CLOCK/TIMER (or TIMER/
SNOOZE on the unit), the unit enters the timer
setting mode. (See page 20.)
Repeat steps 2 and 3 of the procedure of
3
"Setting the Clock."
4 Press and hold CLOCK/TIMER (or TIMER/
SNOOZE on the unit) again so that the
(timer) indicator goes off.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and
some countries use 10 kHz spacing.
When shipped, the built-in AM tuner is set to 9 kHz
spacing. You can change it to 9 kHz or 10 kHz spacing
only while the unit is on standby.
On the unit ONLY:
To select 10 kHz intervals,
while holding ¢.
press
To select 9 kHz intervals,
while holding 4.
press
When you change the setting
The preset stations are erased. You will need to preset the
stations again. (See page 12.)
Continued
DISPLAY
10