Process Flow For A Stove With A Water Jacket - PRITY PLW11 Technical Description And Operation Instructions

- Room thermostat – Option for connecting a room thermostat with relay output
(mechanical relay) and normally open contact. Connection is done to the PCB in the
place of the room temperature sensor А1n1.
- Internet – only when using a Wi-Fi module for remote monitoring of the appliance's
operation and for the software updates.
Main menu → Current values, where you will have the required essential information
about the status and the work parameters.
Main menu → Clock /Timer
IMPORTANT! Manual starting up and shutting down has priority!
- In order to start work on the "Weekly timer" or the "Delayed start" - the stove must be in
Standby mode.
- The stove has been manually started and works – in order to start work on Timer, it must
be shut down manually and then the timer will start working in accordance with its pre-set
program.
- The stove is working in Timer mode and is shut down manually, it must be restarted, in
order to start working according to the pre-set Timer.
- The weekly timer has factory setting Status - > Off. In order to turn it on, it is necessary
that the stove is shut down in "Ready" mode.
Select Main menu → Clock / Timer → Programming – the screen shows days of the week,
and each field is for the respective hour of the day – if marked -> it works, and if only
underlined - > it does not work. Using the "
and using the "START/STOP" button – confirm it. For the specific day we need to program
specific hours for the stove to work. Using "START/STOP" button we can switch to the next
hour. Using the "
-> underscore " _ " (does not work). Using "MENU" button you can return to the previous
screen. Then the status is changed into "On" and we confirm using the "START/STOP" button.
- Set up the exact date and time. You can select "Delayed start" or programming for the
entire week using "Weekly timer".
5.3.4. Process flow for a stove with a water jacket
Ready
PRITY PELLET STOVE
" buttons you can select respectively,:
<Ready>
The stove is ready for work.
No command for work has been sent.
Required conditions for transition to the next mode:
* Stove start command: Pressing and holding the Start
button for more than 3 sec.
* Programmed weekly timer.
" buttons you can select the specific week day
-> full field " █ " ( works) ,
- 39 -