Contents Safety information....................6 Overview........................8 Installing the ILD ...................... 9 Connecting AC power .....................11 Connecting to control data..................12 ................... 14 Service........................16 ......................17...
WARNING! Read the safety precautions in this section before installing, powering or operating this product. The ILD is intended for professional use only. It is not suitable for household use. Review the following safety precautions carefully before installing or operating the device.
Page 7
WARNING! Take measures to prevent personal injury. Install only in a well-ventilated space. Do not paint, cover, or modify the device. Take precautions to prevent injury due to falls when working at height. Ensure that the device is always securely fastened with suitable hardware. For elevated installations, always comply with relevant load dimensioning and safety standards and requirements.
Overview and controlled using a lighting controller or computer-based Artnet controller. Dust, to the degree that there is no ingress of dust. Lower pressure jets of water from any direction.
Installing the ILD WARNING! Always secure an elevated ILD with a safety cable as backup The ILD may be installed in any orientation. Work area below is blocked from public access and make sure the work is performed from a stable platform.
Page 10
M6 hardware. To attach an ILD to a bracket, slide the t-bolts into the attachment rail in the ILD casing (A), turn the bolt 90 degrees so that its head is under the rail rim, and then...
Connecting AC power national standard and is rated 16 A minimum, and use corresponding power outlet sockets. Follow the connector incorporate a fuse or circuit breaker for fault protection. Connecting LED pixels ILD connector.
The device complies with the Artnet communications protocol. It must be connected to an Artnet compliant LAN using an Ethernet cable with an RJ-45 connector. The ILD can feed control signals to other driver devices from a single network port or computer, and use an Ethernet switch if more than...
Page 14
SGM Artnet . The issues can occur, as an ILD may not supply more than 150 W).
Page 15
As an alternative to connecting the device to power and using the , one or more...
Service There are no user-serviceable components inside the device. Do not open the ILD, as doing so is likely to damage its ingress protection. Consult your SGM dealer if the device operates abnormally, is defective or otherwise in need of...
Page 17
PHYSICAL .................. CONSTRUCTION ................................Steel Finish ..................................INSTALLATION Orientation ................................Any AMBIENT OPERATING CONDITIONS ) ...................... 40° C (104° F) Minimum ambient temperature (T ) ......................-10° C (14° F) Operating humidity .............................. 100% ................................
Page 18
PROGRAMMING AND CONTROL ................................. Software upgrade ..................Wireless interface ......via RFID using an Android telephone that has NFC support and SGM Tools app CONNECTIONS Artnet data input .......................... RJ-45 female socket Artnet data output ........................RJ-45 female socket ......
Need help?
Do you have a question about the ILD and is the answer not in the manual?
Questions and answers