Web Address; System Configuration - Carrier AquaEdge 19XR Controls Operation And Troubleshooting

To change IP address manually, press TCP/IP Address to
display the TCP/IP Address screen. See Fig. 59.
TCP/IP Address
Network
.
172 30
2
1
4 5
7 8
Fig. 59 — TCP/IP Address Screen
Enter the new address and validate it by pressing OK. Re-
turn to the Network screen and enter the subnet mask and de-
fault gateway using the same method. Then return to the appli-
cation and save the changes. See Fig. 60.
Fig. 60 — Save Changes
This configuration is normally done at
Web Address —
the factory and is not typically modified in the field. To check
the parameters, press Web Connection. The Startup Connection
screen is displayed. See Fig. 61.
Fig. 61 — Startup Connection
i
Help
. .
101 103
<= =>
3
clr prv
6
9 0 ok
a19-2162
If needed, press "Edit Connection." See Fig. 62. Default pa-
rameters are shown; to modify, press a specific parameter.
1 — Connection Name: startup
2 — Start Page Name: hmi.html
3 — Remote host IP: Not applicable for the application.
Do not modify.
4 — Remote port: Not applicable for the application.
Do not modify.
5 — Remote password: Not applicable for the application.
Do not modify.
Fig. 62 — Edit Connection
System Configuration —
(see Touch Screen Settings for the Controller on page 49),
press System. The System screen is displayed. See Fig. 63.
Setup
Info
Settings
Special
Log
FW download
Reboot
1 — Software version
2 — Settings: Systems Settings
3 — Special: Reset to 0, flash formatting, clock parameters.
Do not modify.
4 — Log: Unit start-up history
5 — Firmware update (not applicable)
6 — Unit reboot
Fig. 63 — System Screen
Press Info on the System screen to display detailed informa-
tion about the HMI panel. See Fig. 64.
50
1
hmi.html
2
127.0.0.1
3
4
5
6 6
LEGEND
On the main Setup screen
System
1
2
3
4
a19-2164
5
6
LEGEND