ADURO Hybrid Faq

ADURO Hybrid Faq

Cleaning stove

Advertisement

Daily Cleaning

Clean the glass so the stove looks presentable.
Remove the ash under the burning cave (For every 15 kg of pellets burned, which is equal to
approximately 8 hours in operation on heat level 3):
o
Place the cave to the side (use pliers) see picture 1 and use gloves if necessary for extra
protection.
o
Scrape the ash under the cave away into the grate (see picture 2).
o
Put the burning cave back in its place.
The cleaning takes less than 3 minutes to complete. However, if the lid is open for more than 3 minutes, the
stove will automatically turn off out of safety reasons. We do not recommend that you turn off the stove when
conducting this fast cleaning, otherwise the igniter will be quickly worn down. It may be necessary to do this
cleaning every 7 to 8 hours of operation if the stove is running at heat level 3.
See this video for guidance:

Weekly cleaning

Vacuum clean inside of the stove, inside the small auger under the cave (once every 3-4 day).
Remove ashpan and clean the room of the ashpan.
Dry dust of the stove so it keeps its new look.

Additional cleaning if needed

This cleaning is necessary if you find that the combustion is getting worse. This may be due to dust and
ashes reducing the air flow in the stove.
Remove ashes and cinders from the burning cave and combustion chamber.
Empty the ashpan.
Vacuum clean the inside of the combustion chamber and in the burning cave to clean the upper part
of the auger.
Pellet stoves form dust in the stove and air pathways. The amount depends on the pellet type. Much
of this dust is burned when the stove is used in wood mode, because the temperature is higher.
FAQ Cleaning the Hybrid stove
https://www.youtube.com/watch?v=MbCXLdixreM
(watch from 08:05).

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hybrid and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ADURO Hybrid

  • Page 1 FAQ Cleaning the Hybrid stove Daily Cleaning • Clean the glass so the stove looks presentable. • Remove the ash under the burning cave (For every 15 kg of pellets burned, which is equal to approximately 8 hours in operation on heat level 3): Place the cave to the side (use pliers) see picture 1 and use gloves if necessary for extra protection.
  • Page 2 Depending on the use, it will be necessary to clean the stove at the top of the combustion chamber. Carefully remove the fireproof tile in vermiculite on the left, the baffle plate in vermiculite, and the baffle plate in steel. Vacuum clean the upper part of the stove. Remove the bottom fireproof tile in vermiculite, remove the plate in the back (see picture 7 below) and vacuum clean the combustion air chamber.
  • Page 3 We recommend a service visit where the stove can be checked that everything is working. This can be done by contacting us at info@aduro.dk • Spray Senotherm on the outside of the stove to maintain the fresh look i.e. those places that have...

Table of Contents