Table of Contents
Advertisement
Fitting the transport locking device
on driving end (KS)
Note:
Always use the screws supplied with or installed in the transport locking device to secure it on the en‐
gine.
1.
Secure the two plates (2) with screws (6) and washers (5) at the bores on both sides of the flywheel
housing and tighten to the specified tightening torque.
Name
Screw
2.
Screw nut (3) onto screws (4) up to the end of the thread.
3.
Fit the locks (1) through the openings of plates (2) and fasten with the screws (4).
4.
Tighten screws (4) alternately with torque wrench to the specified tightening torque.
Name
Screw
5.
Screw on nuts (3) of both screws (4) at plates (2) and secure.
6.
Fit label (7) to mark the engine as "Fitted with transport locking device".
Removing the transport locking
device from driving end (KS)
1.
Release the locknuts (3) on both sides of
the flywheel housing, remove screws (4)
and take off the two locks (1).
2.
Remove screws (6) with washers (5), label
(7) and plates (2)..
3.
Store the removed parts of the transport
locking device carefully for possible reuse.
Size
Type
M16
Tightening torque
Size
Type
M10
Tightening torque
Lubricant
Value/Standard
(Engine oil)
250 Nm +25 Nm
Lubricant
Value/Standard
(Engine oil)
30 Nm +3 Nm
MS150054/02E 2012-02 | Safety | 9
Advertisement
Table of Contents
