Operation; Maintenance - Billy Goat PL1801H Owner's Manual

Operation

TURNING: At the end of an aerating run, release the bail and raise the tines out of the ground. Then repo-
sition the unit for another pass and lower the tines to begin another run.
TRANSPORT: Be sure to raise tines out of the ground (disengaging the bail and then raising the tines with
the center lever) before transporting away from the work area.
TIPS
MOW: Mow the lawn to its normal cut height.
WATER: For the best performance and maximum tine penetration the lawn should be thoroughly watered
the day before aeration.
INSPECT: Check the lawn before beginning work. Remove all rocks, wire, string, or other objects that can
present a hazard during work prior to starting.
IDENTIFY: Mark all fixed objects to be avoided during work, such as sprinkler heads, water valves, buried
cables, or clothes line anchors, etc.
SLOPES: Do not operate the aerator on steep slopes (exceeding 15
ing on any sloped surface. For lesser sloped areas operate the unit, traversing up and down at a 45
to the slope rather than straight across. Extended operation on steep slopes can cause engine damage.

Maintenance

PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals:
Maintenance Operation
Inspect for loose, worn or damaged parts
Check engine oil*
Clean debris from unit and tines
Grease cam bearings
Inspect belt for wear
Replace tine bushings
Grease shaft bearings
*Engine must be level when checking or filling oil. Refer to your Honda or Briggs and Stratton engine manual for
proper engine maintenance procedures.
Part No. 382510
). Use extreme caution when operat-
o
Every Every 10
Use Hrs
•
•
•
•
7
Every 50 Every 100
Hrs Hrs
•
•
•
angle
o
382510_B_HI