Table of Contents
Advertisement
FIBER OneShot Users Manual
How to Use the Meter
Always use patch cords that comply with GR-326-CORE
specifications. Other patch cords can cause unreliable
measurements.
Do not use the meter to measure fibers that have PC
connectors. PC connectors cause large reflections that
the meter shows as the end of the fiber.
Clean all fiber connectors.
1
Connect the fiber to the meter, as shown in Figure 6.
2
To connect to APC connectors, use a UPC/APC patch cord. To
connect to UPC connectors, use a UPC/UPC patch cord.
Turn on the meter, then press
3
After you turn on the meter, it shows
time to show that it operates correctly.
If ACTIVE LINE blinks, immediately disconnect the
meter from the fiber. Optical power levels more than
+7 dBm can cause damage to the detector in the
meter.
12
Notes
T
.
Note
W
Caution
for a short
Advertisement
Table of Contents
