Exabyte 110L LTO Ultrium AUTOLOADER Field Instruction page 3

C
ONTENTS OF THE
The tape drive kit contains one of the following LTO Ultrium tape drives
pre-installed in a drive carrier:
4
4
4
4
P R
REPARING FOR
1. 1. 1. 1.
2. 2. 2. 2.
3. 3. 3. 3.
E 110L, 221L, 221L-FC
XABYTE AND
T D K
APE RIVE IT
SCSI LTO Ultrium 1
SCSI LTO Ultrium 2
Fibre Channel LTO Ultrium 1
Fibre Channel LTO Ultrium 2
If you are upgrading a 221L library from SCSI to Fibre Channel
Important
or from Fibre Channel LTO Ultrium 1 to Fibre Channel LTO
Ultrium 2, contact Exabyte Technical Support (1-303-417-7792)
to determine whether your library needs additional hardware
upgrades.
EPLACEMENT
Obtain a #2 Phillips screwdriver.
Ensure that the environment is free of conditions that could cause
electrostatic discharge (ESD). If possible, use an antistatic mat and
grounded static protection wristband during installation. If a mat and
wristband are not available, touch a known grounded surface, such as a
computer's metal chassis.
Before powering off the library or autoloader, make sure it is not
Important
communicating across the SCSI bus. Powering off the library or
autoloader may disrupt communication on the SCSI bus.
Power off the library or autoloader and disconnect the power cord.
Before performing this procedure, be sure that the power switch
Important
is in the off position and the power cord is disconnected from
the outlet.
I R
NSTALLING OR EPLACING A
1 B Y B
EFORE OU EGIN
T D
APE RIVE
3 8
OF