Fill Product Simulation Bottle - Follett FZR20-LB Installation, Operation And Service Manual

Fill product simulation bottle

1. Remove probe and cap from the top bottle and fill with solution used at
your facility (e.g., 60% glycerine and 40% water) (Fig. 4). Replace cap
and reinsert probe sensor.
2. If equipped with a bottom probe, perform same procedure for bottom
bottle.
It is imperative that the top probe bottle be filled with a solution that your
facility uses to ensure proper operation of unit.
3. Press lower left corner of front facade door to access power switch
inside (Fig. 5.1).
4. Press power switch to turn unit on (Fig. 6.1).
5. Install (2) 9 V back-up interface batteries (Fig. 6.2) and (1) 9 V chart
recorder back-up battery (if equipped.)
6 Installation
ATTENTION INSTALLER
Fig. 4
Fig. 5
1
Fig. 6
1
2
00981795R03 – FZR20/25 LB, PL