Table of Contents
Advertisement
Installation
• Do not tilt any unit further than 30° off vertical during uncrating or installation
• Refrigeration module area contains mechanical, moving parts. Keep hands and arms clear of this area at all
times. If access to this area is required, power to unit must be disconnected first.
1. Remove key attached to lock catch and unlock door.
2. Remove casters from box packed inside freezer.
Note: California facilities requiring wall and floor anchors – refer to wall anchor
kit instructions (#00938241) packed with seismic kit before proceeding with
caster installation.
3. Unbolt freezer from pallet.
4. Rotate freezer on pallet to install casters (Fig. 1.1).
5. Install casters by hand one at a time using channel locks to tighten, until
caster meets against the bottom of cabinet (Fig. 1.2).
6. Peel protective film from exterior walls of stainless cabinet.
Adjust self-closing door
1. Roll freezer to desired location and lock as many casters as possible
(Fig 2.1).
2. If the door appears to be sagging, remove the philips screw (Fig. 2.2)
holding the Hold Open Bracket to the Hinge Bracket to gain access to
the Sag Adjustment Screw (Fig. 2.3). Turn the Sag Adjustment Screw to
align the door squarely with the freezer cabinet. When finished, reinstall
the Hold Open Bracket.
3. Check door for closing tension and adjust if necessary. To check
closing tension, open door 1" (25.4 mm) and turn screw (Fig. 2.4)
counterclockwise until you achieve positive close. Then, turn another full
turn counterclockwise to ensure door has sufficient closing tension.
Install shelves (if equipped) and power up
1. If freezer is equipped with shelves, remove bag containing shelf
supports and position them in desired locations on each pilaster and
insert shelves (Fig. 3).
2. Plug freezer into a 120 V 60 Hz 20A dedicated outlet.
00981795R03 – FZR20/25 LB, PL
DANGER
Fig. 1
1
Fig. 2
Hold Open
Bracket
Fig. 3
1
2
Installation
2
2
4
3
1
3
5
Hide quick links:
Advertisement
Table of Contents
