☛ ☛ ☛ ☛ 2.
Pull out the multi-purpose extension flap.
☛ ☛ ☛ ☛ 3.
Open the face up output tray, and then pull out the face up output tray
extension if necessary.
✒ ✒ ✒ ✒ Note
Envelopes that have been creased after they have been printed:
At the back of the printer open the face-up output tray, push down the blue
tabs at the left and right-hand sides as shown in the diagram below. When
you have finished printing your envlope(s) close the face up output tray to re-
set the blue tabs automatically or re-set the blue tabs manually by pushing
the blue tabs back to their original position.
Fig. 1-17
Fig. 1-18
1-29
CHAPTER 1 ABOUT THIS PRINTER