Brother HL-2460 Series User Manual page 167

E r r o r M e s s a g e
E r r o r M e s s a g e
E r r o r M e s s a g e
MEDIA TYPE ERROR
MANUAL FEED
SIZE ERROR XXX
NO TRAY ID XXX
SIZE ERROR DX
SIZE ERROR MX
NO DX UNIT
DX LEVER ERROR
NO MX UNIT
DIMM ERROR
CARD ERROR
HDD ERROR
CARD REMOVAL
LINE ERROR
BUFFER ERROR
STORAGE FULL
A c t i o n
A c t i o n
A c t i o n
Specify the correct media type: XX.
The size of paper in the multi-purpose tray is wrong. Load the correct
size of paper in the multi-purpose tray, or while the printer is in Stop
mode, and then press the
Set the correct paper that you want to use into the indicated tray, or
load the same size paper that you selected in the current driver
setting. "What kind of paper can I use?" in Chapter 1.
Install the specified ID tray.
Set the correct paper that you want to use, or load the same size
paper that you selected in the current driver setting.
paper can I use?" in Chapter 1.
Set the correct paper that you want to use, or load the same size
paper that you selected in the current driver setting.
paper can I use?" in Chapter 1.
Install the duplex unit correctly. See the duplex unit User's Guide.
Set the duplex lever to the correct position.
Change the job properties or install the Mailbox unit correctly.
Install the DIMM correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new card.
Make sure of the following points:
• The cable is connected correctly.
• The card is installed correctly.
• The installed card is formatted correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new card.
Make sure of the following points:
• The cable is connected correctly.
• The HDD is installed correctly.
• The installed HDD is formatted correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new HDD.
Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new CompactFlash
card.
Check the Serial interface settings. (baud rate, code type, parity and
hand shake protocols).
Check the Interface settings.
Delete unnecessary macros or fonts, or use a new card or HDD.
6–2
Go switch.
See "What kind of
See "What kind of