Handling The Remote Controller - Vivax Y-DESIGN ACP-09CH25AEYI User Manual

HANDLING THE REMOTE CONTROLLER

NOT SURE WHAT A FUNCTION DOES? Refer to the How to Use Basic Functions and How to
Use Advanced Functions sections of this manual for a detailed description of how to use your air
conditioner.
SPECIAL NOTE
- Button designs on your unit may differ slightly from the example shown.
- If the indoor unit does not have a particular function, pressing that function s button on the remote
control will have no effect.
INSERTING AND REPLACING BATTERIES
Your air conditioning unit comes with two AAA batteries. Put the batteries in the remote control
before use:
1. Remove the back cover from the remote control, exposing the battery compartment.
2. Insert the batteries, paying attention to match up the (+) and (-) ends of the batteries with the
symbols inside the battery compartment.
3. Install the back cover on.
INSTALLING REMOTE CONTROL HOLDER
The remote controller can be attached to a wall or stand by using a remote controller holder (optional
part, not supplied with the unit).
1. Before installing the remote controller, check that the air conditioner receives the signals properly.
2. Install the holder with two screws.
3. Put the remote controller in the holder.
BATTERY NOTES
For optimum product performance:
- Do not mix old and new batteries, or batteries of different types.
Do not leave batteries in the remote control if you don
-
months.
BATTERY DISPOSAL
Do not dispose of batteries as unsorted municipal waste. Refer to local laws for proper disposal of
batteries.
TIPS FOR USING REMOTE CONTROL
• The remote control must be used within 8 meters of the unit.
• The unit will beep when remote signal is received.
• Curtains, other materials and direct sunlight can interfere with the infrared signal receiver.
• Remove batteries if the remote control will not be used more than 2 months.
Remove the back cover
to install batteries
t plan on using the device for more than 2
'
Put the remote
controller in the holder.
23