Handling The Remote Controller - Vivax CP-12CH35AEHI+R32 User Manual

ENG

Handling the remote controller

Replacing batteries
Location of the remote controller
Use the remote controller within a distance of
8 meters from the appliance, pointing it
towards the receiver. Reception is confirmed
by a beep
.
CAUTIONS

The air conditioner will not operate if
curtains, doors or other materials block the
signals from the remote controller to the
indoor unit.

Prevent any liquid from falling into the
remote controller. Do not expose the remote
controller to direct sunlight or heat.

If the infrared signal receiver on the indoor
unit is exposed to direct sunlight, the air
conditioner may not function properly. Use
curtains to prevent the sunlight from falling
on the receiver.

If other electrical appliances react to the
remote controller, either move these
appliances or consult your local dealer.

Do not drop the remote controller. Handle
with care. Do not place heavy objects on the
remote controller, or step on it.
The following cases signify exhausted
batteries. Replace old batteries with new
ones.

Receiving beep is not emitted
when a signal is transmitted.

Indicator fades away.
The remote controller is powered by two
dry batteries (R03/LR03X2) housed in the
back rear part and protected by a cover.
Remove the cover in the rear part
(1)
of the remote controller.
Remove the old batteries and insert the new
(2)
batteries placing the (+) and (-) ends correctly.
Install the cover back on.
(3)
37
-
VIVAX
.