Setup; Tests; The Test Or Quick Start Menu - Ametek 200 Series Quick Start Manual And Safety Instructions

AMETEK CTS
F3 Setup
Opens the setup menu.
5.2.

Setup

In the setup menu, you can choose the language and other device settings.
SETUP
F1 : Change language / Sprache ändern
F2 : LCD backlighting
F3 : Interfaces
F4 : Keyboard-Beeper
F5 : Power-on counter
F1 F2 F3
F1 Change language
The user can chose between two languages, German and English.
F2 LCD backlighting
With the use of F2 the backlighting can be switched On or Off. Additionally the Auto Off function can be
programmed to switch off the backlighting after a specified time the generator has not been in operation (1 -
30min).
F3 Interfaces
This menu will help the user to define the status of the integrated serial and parallel interfaces, e.g. the baud rate
of the RS 232 or the address of the IEEE interface.
F4 Keyboard-Beeper
F1 is the selector for the beeper ON/OFF mode.
The beeper is always on when a test routine is finished. To indicate that a running test is finished the beeper
sounds 3 times.
F5 Power-on counter
Pressing of F5 will show the total power-on time and testing time of the test equipment.
5.3.

Tests

The following sections shows the common menu-items.
5.3.1.

The Test or Quick Start Menu

When you select either a test, or Quick Start, when available, you can set, and change the various parameters or
press START to start the test.
Consulte the applicatlbe manufacturer or international standard to set the applicable parameters before starting
the test.
QUICK START
V = 100 V
+/- = -
t1 = 1.0 s
tri = Auto
n = 10000
START CHANGE
F1 F2 F3
F4 F5 F6
pul = 2
Ri = 10 Ohm
t2 = 8.0ms
cpl = Supply
F4 F5 F6
F7
F7
1.00
Automotive Transient Immunity Testing
21 / 26