Supermicro SuperBlade SBS-820H-420P User Manual page 45

Installing a Drive
1. Remove the dummy drive, which comes pre-installed in the drive carrier. Pull out the two
spring locking clasps and lift out the dummy drive.
Locking Clasps
Figure 3-7. Removing the Dummy Drive from a Carrier
2. Position the drive into the carrier with the PCB side facing down and the connector end
toward the rear of the carrier.
3. Tilt the drive to insert it onto the two posts on the right inside of the carrier.
4. Pull out the two spring locking clasps to allow the drive to sit fully in the carrier, then
release them to secure the drive.
5. Insert the drive carrier into its bay, keeping the release button on the bottom. When the
carrier reaches the rear of the bay, the release handle will retract.
6. Push the handle in until it clicks into its locked position
Post
Post
SB414_25HDD_TRAY_ASSY_REF
45
Chapter 3: Installation and Setup