Brother Innov-is 500D Operation Manual page 47

SE-BrotherE_sgml.book Page 41 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Place a different presser foot below the holder
so that the presser foot pin is aligned with the
notch in the holder.
Position the presser foot so the letter indicating
the presser foot type (A, G, I, J, M, N or R) is
positioned to be read.
Presser foot holder
Notch
Pin
Slowly lower the presser foot lever so that the
presser foot pin snaps into the notch in the
presser foot holder.
Presser foot lever
The presser foot is attached.
Raise the presser foot lever to check that the
presser foot is securely attached.
Note
When a stitch is selected, the icon for the
presser foot that should be used appears in
the screen. Check that the correct presser
foot is attached before starting to sew. If the
wrong presser foot is installed, turn off the
sewing machine, attach the correct presser
foot, and then select the desired stitch again.
Buttonhole foot "A"
Overcasting foot "G"
Zigzag foot "J"
Button fitting foot "M"
Monogramming foot "N"
Blind stitch foot "R"
Side cutter "S"
Embroidery foot "Q"
For details on the presser foot that should be
used with the selected stitch, refer to "Stitch
Settings" (page 66).
Replacing the Presser Foot 41