Darning - Brother Innov-is 500D Operation Manual

SE-BrotherE_sgml.book Page 105 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Darning

Fabric that has been torn can be darned.
Darning is sewn as shown below.
Reinforcement stitching
Determine the desired length of the darning.
Set the button guide plate on buttonhole foot
"A" to the desired length. (The distance between
the markings on the presser foot scale is 5 mm
(3/16 inch).)
Presser foot scale
Length of darning
5 mm (3/16 inch)
7 mm (1/4 inch)
• A bar tack with a maximum length of about
28 mm (1-1/8 inch) can be sewn.
Attach buttonhole foot "A".
• For details, refer to "Replacing the presser
foot" (page 40).
52 53
Select stitch or .
• For details, refer to "Selecting stitching" (page
47).
Position the fabric so that the needle is 2 mm
(1/16 inch) in front of the area to be darned,
and then lower the presser foot lever.
Tear
2 mm (1/16 inch)
Pass the upper thread down through the hole in
the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
darning will not be sewn with the correct
size.
Reinforcement Stitching 105