Brother Innov-is 500D Operation Manual page 25

SE-BrotherE_sgml.book Page 19 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Place the bobbin on the bobbin winder shaft so
that the spring on the shaft fits into the notch
in the bobbin.
Notch
Bobbin winder shaft spring
Slide the bobbin winder shaft to the right.
Place the spool of thread for the bobbin onto
the bobbin thread spool pin.
• Use the special Brother embroidery bobbin
thread when embroidering.
Slide the spool cap onto the bobbin thread
spool pin.
With the rounded side of the spool cap
positioned toward the left, slide the spool cap
onto the bobbin thread spool pin as far as
possible until the right side of the spool touches
the right end of the bobbin thread spool pin.
CAUTION
● Two spool cap sizes are available,
allowing you to choose a spool cap that
best fits the size of spool being used. If the
spool cap is too small for the spool being
used, the thread may catch on the slit in
the spool or the needle may break.
●
Note
If a spool of thread 12 mm (1/2 inch) in
diameter and 75 mm (3 inch) high is inserted
onto the bobbin thread spool pin, use the
special spool cap.
12 mm (1/2 inch)
75 mm (3 inch)
Winding/Installing the Bobbin 19