Brother Innov-is 500D Operation Manual page 45

SE-BrotherE_sgml.book Page 39 Monday, June 30, 2003 3:44 PM
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Using the screwdriver, loosen the needle
clamp screw.
Lower the needle-changing tool.
The needle can be removed from the needle
bar.
Insert the new needle into the hole in the
needle-changing tool.
Insert the needle with the flat side of the needle
toward the rear of the machine.
Lift up the needle-changing tool so that the
fork hooks onto the needle clamp screw.
Insert the needle until it touches the needle
stopper, and then use the screwdriver to
tighten the needle clamp screw.
The needle is installed.
Lower the needle-changing tool off of the
needle.
Note
The needle-changing tool can not be used
for the twin needle.
Replacing the Needle 39