Brother CS-80 Operation Manual page 92

S2_brotherE.book Page 86 Thursday, February 13, 2003 11:03 AM
UTILITY STITCHES ———————————————————————————————————————————————————————
2 Attach buttonhole foot "A".
• For details, refer to " Replacing the presser
foot" (page 35).
3 Select stitch .
• For details, refer to " Selecting stitching"
(page 58).
4 Position the fabric so that the opening of the
pocket faces toward you, and then lower the
presser foot lever so that the needle drops
2 mm (1/16 inch) in front of the pocket
opening.
1 2 mm (1/16 inch)
Pass the upper thread down through the hole
in the presser foot.
• When lowering the presser foot, do not push
in the front of the presser foot, otherwise the
bar tack will not be sewn with the correct
size.
1 Do not reduce the gap.
5 Pull down the buttonhole lever as far as
possible.
1
1 Buttonhole lever
86
6
1
7
8
1
The buttonhole lever is positioned behind the
bracket on the buttonhole foot.
1
2
1 Buttonhole lever
2 Bracket
Gently hold the end of the upper thread in
your left hand, and then start sewing.
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
Raise the presser foot lever, remove the
fabric, and cut the thread.
Raise the buttonhole lever to its original
position.
Memo
G If the fabric does not feed, for example,
because it is too thick, increase the stitch
length. For details, refer to " Adjusting the
stitch length" (page 52).