Brother CS-80 Operation Manual page 69

S2_brotherE.book Page 63 Thursday, February 13, 2003 11:03 AM
4 Raise the presser foot lever to check that the
side cutter is securely attached.
CAUTION
G
If the thread cassette is to be installed
with the side cutter attached, be sure to
lower the presser foot lever. If the
presser foot lever remains raised, the
needle threader will hit the presser foot,
which may result in damages.
5 Pass the upper thread under the side cutter,
and then pull it out toward the rear of the
sewing machine.
6 Select a stitch.
• For details, refer to " Selecting stitching"
(page 58).
CAUTION
G
After adjusting the stitch width, slowly
turn the balance wheel toward you and
check that the needle does not touch the
presser foot. If the needle hits the presser
foot, the needle may bend or break.
7 Make a cut of about 2 cm (1/16 inch) long in
the fabric at the beginning of the stitching.
1 2 cm (1/16 inch)
8
1
Position the fabric in the side cutter.
The cut in the fabric should be positioned over
the guide plate of the side cutter.
1
1 Guide plate
• If the fabric is not positioned correctly, the
fabric will not be cut.
9 Lower the presser foot lever, and then start
sewing.
A seam allowance is cut while the stitching
is sewn.
• If the stitching is sewn in a straight line, the
seam allowance will be about 5 mm
(3/16 inch).
1
1 5 mm (3/16 inch)
Memo
G The side cutter can cut as much as one layer
of 13-oz. denim.
G After using the side cutter, clean it by
removing any lint or dust.
G If the side cutter can no longer cut fabric,
use a rag to apply a small amount of oil to
the cutting edge of the cutter.
Overcasting Stitches
3
63