Inserting A Side Zipper - Brother CS-80 Operation Manual

S2_brotherE.book Page 74 Thursday, February 13, 2003 11:03 AM
UTILITY STITCHES ———————————————————————————————————————————————————————
6 Select stitch .
• For details, refer to " Selecting stitching"
(page 58).
CAUTION
G
When using zipper foot "I", be sure to
select the straight stitch (center needle
position), and slowly turn the balance
wheel toward you to check that the
needle does not touch the presser foot. If
a different stitch is selected or the needle
hits the presser foot, the needle may
bend or break.
7 Topstitch around the zipper.
1 Stitching
2 Right side of fabric
3 Basting stitching
4 End of zipper opening
CAUTION
G
When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
8 Remove the basting stitching.
74

Inserting a side zipper

Stitching is sewn on only one piece of fabric. Use
this type of zipper for side openings and back
openings.
1
1 Stitching
2 Right side of fabric
3 End of zipper opening
The following procedure will describe how to stitch
on the left side, as shown in the illustration.
1 Attach zigzag foot "J" and sew straight
stitches up to the zipper opening.
With the right sides of the fabric facing each
other, sew reverse stitches after reaching the
zipper opening.
• For details, refer to " Basic Stitching"
(page 64).
2 Using a basting stitch, continue sewing to the
edge of the fabric.
1
2
1 Basting stitching
2 Reverse stitches
3 Wrong side of fabric
4 End of zipper opening
3 Press open the seam allowance from the
wrong side of the fabric.
1
1 Wrong side of fabric
2
3
3
4