Brother CS-80 Operation Manual page 20

S2_brotherE.book Page 14 Thursday, February 13, 2003 11:03 AM
GETTING READY ————————————————————————————————————————————————————————
Memo
G When using thread that winds off quickly,
such as transparent nylon thread or metallic
thread, place the enclosed spool net over
the spool before placing the spool of thread
onto the spool pin.
If the spool net is too long, fold it to fit the
size of the spool.
1
3
2
1 Spool net
2 Spool
3 Spool pin
4 Spool cap
8 Pull out some thread, and then thread the
thread guide for bobbin winding.
Hold the thread with both hands, and then
securely pass the thread as far as possible into
the two slits in the thread guide.
1
2
1 Thread guide for bobbin winding
2 Two slits
14
9 While using your left hand to hold the end of
the thread that wraps around the thread guide
for bobbin winding, use your right hand to
wind the free end of the thread clockwise
around the bobbin five or six times.
4
0 Pull the thread to the right and pass it through
the slit in the bobbin winder seat.
1 Slit in bobbin winder seat (with built-in cutter)
G
Be sure to cut the thread as described. If
the bobbin is wound without cutting the
thread using the cutter built into the slit
in the bobbin winder seat, the thread
may become tangled in the bobbin or the
needle may bend or break when the
bobbin thread starts to run out.
1
The thread is cut to a suitable length.
CAUTION