Appliqué Stitching - Brother CS-80 Operation Manual

S2_brotherE.book Page 80 Thursday, February 13, 2003 11:03 AM
UTILITY STITCHES ———————————————————————————————————————————————————————
Appliqué stitching
1 Cut out the appliqué, leaving a seam
allowance of between 3 and 5 mm
(1/8 and 3/16 inch).
1 Seam allowance
2 Place a pattern made of thick paper on the
back of the appliqué, and then fold over the
seam allowance using an iron.
• Remove the thick paper after pressing the
seam allowance.
3 Turn the fabric over, and then baste or pin it
onto the fabric that it will be attached to.
1
1 Basting stitching
4 Attach zigzag foot "J".
• For details, refer to " Replacing the presser
foot" (page 35).
80
1
J
5 Select a stitch.
• For details, refer to " Selecting stitching"
(page 58).
6 Turn the balance wheel toward you, and then
begin sewing around the edge of the appliqué,
making sure that the needle drops just outside
of the appliqué.
When sewing around corners, stop the
machine with the needle in the fabric just
outside of the appliqué, raise the presser foot
lever, and then turn the fabric as needed to
change the sewing direction.