Turning The Panel Off And Back On; Disconnecting The Panel From The Power Supply; Windows Has Unrecoverable Problems; Technical Support - PEAKnx Controlmini User Manual

User manual, Controlmini

9.1.1 Turning the panel off and back on

If the operating system cannot be shut down, the panel must be turned off manually and a
reboot must be forced.
Note: Any data that has not been saved might be lost when forcing a restart.


Forced restart
▪ Press and hold the On/Off button (C2) for more than 5 seconds.
The panel switches off.
After shutting down, leave the panel switched off for 10 seconds.
Switch on the panel by pressing the On/Off button (C2) again.
▪

9.1.2 Disconnecting the panel from the power supply

If the problem cannot be solved by restarting the panel, you must disconnect the panel from the
power supply.
Disconnect the circuit breaker of the panel in the building's control cabinet for at least one
▪
minute.

9.2 Windows has unrecoverable problems

If the Windows user interface shows unrecoverable problems, the operating system can be
reset to factory settings. If you have created an image with the PEAKnx Recovery USB flash
drive after commissioning, you will find further instructions for restoring the image in the quick
start guide of the recovery USB flash drive.

9.3 Technical support

If you experience problems with your Controlmini, please contact our PEAKnx Support Team:
− Mail: support@peaknx.com
− Create a Support Ticket: support.peaknx.com
− Phone: +49-6151-279 1825

10 Technical data

Supply
Power supply specification
Connection terminal, conduc-
tor cross section
24 V DC; 2.5 A
rigid: 0.14 mm² - 1.5 mm²
flexible with wire end ferrule without plastic sleeve: 0.25
mm² - 1.5 mm²
23