Advertisement
USER'S GUIDE
The outer sheath of the cord must be secured inside the plug. The coloured wires should
not hang out of the plug.
xiv
If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the
coloured insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction
of the plug permits, leave the green and yellow wire longer than the
others so that, in the event that the cord is pulled out of the plug, the
green and yellow wire will be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter "E" or by the safety
earth symbol
, or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal
which is marked with the letter "N" or coloured black or blue.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter "L" or coloured red or brown.
Advertisement
