Advertisement
The following capacity of a SIMM can be installed:
• 1 Mbyte HITACHI HB56D25632B-6A, -7A,
MITSUBISHI MH25632BJ-7
• 2 Mbyte HITACHI HB56D51232B-6A, -7A
MITSUBISHI MH51232BJ-7
• 4 Mbyte HITACHI HB56A132BV-7A, -7AL, -7B, -7BL
MITSUBISHI MH1M32ADJ-7
• 8 Mbyte HITACHI HB56A232BT-7A, -7AL, -7B, -7BL
MITSUBISHI MH2M32EJ-7, MH2M32DJ-7
In general, the SIMM must have the following specifications:
Type:
72 pin and 32 bit or 36 bit output
Access Time:
Capacity:
1, 2, 4 or 8 Mbyte
Height:
46mm (1.8 inches) or less
There are 40 bit output SIMMs for workstations. Such SIMMs do not
fit to this printer.
For SIMMs and installation, consult the dealer where you purchased
the printer.
When you install SIMMs, follow these steps:
1. Turn off the printer and unplug the power cord from the wall
socket.
Note
Be sure to turn off the power to the printer before installing or
removing the SIMMs.
2. Open the top cover of the printer.
3. Push the tab located on the left inside the printer to unlock the
left side cover.
Fig. 5-4 Unlocking the Left Side Cover
80 nsec. or less
CHAPTER 5 OPTIONS
5–7
Advertisement
