Table of Contents
Advertisement
BURNER FAULTS
Control program under fault conditions and lock-out indication
Whenever a fault occurs, the sequence switch stops and with it the lock-out indicator.
The symbol above the reading mark of the indicator gives the type of fault:
No start
Interruption of startup sequence
Lock-out
Interruption of startup sequence
Lock-out
1
Lock-out
One of the contacts has not closed
Extraneous light
Terminals 6, 7 and 15 remain under voltage until fault has been corrected
18
The contact of the limit thermostat or any other switching
devices in the control loop of terminal 4 to terminal 5 are
opened.
Lock-out during or after completion of the control program
Examples:
– Flame not extinguished
– Leaking fuel valves
– Faulty flame supervision circuit
Defect in the flame supervision circuit, faulty flame signal,
extraneous light
Terminals 6, 7 and 15 remain under voltage until fault has
been corrected
No flame signal is present on completion of the safety time
Flame signal has been lost during operation
Advertisement
Table of Contents
