Q & A; Setting Up The Printer Hardware; Setting Up The Printer For Dos - Brother HL-660 Series User Manual

English
Q & A

Setting up the Printer Hardware

Setting up the Printer for DOS

This section contains questions and answers for using your printer. If you
have encountered a problem, find the question relating to your problem
and take the steps recommended to correct the problem.
Question
The printer does not
work. All lamps are off.
The printer does not print.
Questions
I cannot print from my
application software
Recommendation
The printer may be in sleep mode. Press any
switch to wake up printer.
Check the following:
The protective parts have been removed.
The toner cartridge and drum unit are
installed properly.
The interface cable is securely connected
between the printer and computer.
Check to see if any lamps are blinking.
Notice which lamps are blinking and refer
to Operator Call section of this manual.
Recommendation
Check if the DOS application software
interface settings match that of your printer.
( i.e., if you are using a parallel printer
cable, then you would most likely set your
DOS software printer port to LPT1.)
Check to see if the printer has any printer
alarms active.
CHAPTER 6 TROUBLESHOOTING
6–7