Installation And Connection; Dismantle The Module Box - Alpha-InnoTec SWC H1 Series Operating Manual

6

Installation and connection

6.1 Dismantle the module box

ATTENTION
If the module box is tilted by more than 45°,
compressor oil runs into the cooling circuit.
Do not tilt the module box by more than 45°.
NOTE
If necessary the module box can be
dismantled for easier transport of the unit
or for service reasons.
Steps 1 to 5 are only required if the module
Unit is safely disconnected from the power supply
again.
1. Remove the front
"7.1 Remove
2.
3.
heating.
NOTE
The hose connectors are not part of the
scope of delivery with all KFE ball valves.
Subject to change without notice | 83057200dUK – Translation of the original operating manual | ait-deutschland GmbH
panel of the module
the front panel of
4.
5.
heat source.
6. Disconnect the electrical connections:
tom of the electrical control cabinet. To do this,
release the lugs by pressing on the sides of
the connectors
the top of the module box
-
11